Components Of The Product - Siemens SCALANCE WLC711 Kompaktbetriebsanleitung

3 Description
3.1

Components of the Product

The device is supplied with the following components:
Amount Name
1 SIMATIC WLC711
1 Operating Instructions compact
1 Accessory kit: 2 mounting brackets, 9 oval-head screws (M4x6), 1 USB strain relief
License key
When it is shipped, the WLC711 is already licensed for the connection of up to 16 controller-based SCALANCE W78xC and
SCALANCE W786-2HPW access points.
An upgrade to 32 or 48 access points is also possible with license keys. These licenses for 16 access points, have the order
number 6GK5-907-1SB00.
Make sure that you have the "Certificate of License" available if you make use of the Customer Support of Siemens Industry
Automation and Drives.
3.2 Connection components
Interfaces and power supply
Location of the connector elements
Pos Name
①
24 VDC
②
DVI/VGA
③
USB
④
LAN1: X2 P1
⑤
ADMIN: X2 P2
⑥
COM1
⑦
USB strain-relief
fastener
⑧
PE terminal
SCALANCE WLC711
A5E03740572-05, 04/2016
Description
Connection for a 24 V DC power supply
DVI/VGA connection for CRT or LCD monitor with DVI interface
The interface is not supported.
4 USB 2.0 connections, high-speed / low current
RJ-45 Ethernet connector for 10/100/1000 Mbps, data port ("esa0" interface)
RJ-45 Ethernet connector 2 for 10/100/1000 Mbps, management port ("admin" interface)
Serial port (RS232) 9-pin D-Sub connector
The USB strain relief must be fastened to the device enclosure with an oval-head screw
(M4 thread). The USB cables can be fastened to the strain-relief assembly with a cable
tie.
The PE terminal (M4 thread) must be connected to the protective ground conductor of the
plant, in which the device is to be installed. The minimum conductor cross-section may not
be less than 2.5 mm .
2
17