Technical Information - AEG GS60BFSW Benutzerinformation

80 www.aeg.com
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
12.1 The washing and drying results are not satisfactory
Problem
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry water
drops on glasses and dishes.
The dishes are wet.

13. TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Power consumption
Power consumption
1) Refer to the rating plate for other values.
2) f the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the
hot water supply to decrease energy consumption.
14.
GARANTIE, GARANZIA, GUARANTEE
CH
Kundendienst, service-clientèle,
Servizio clienti, Customer Service
Centres
Refer to "Hints and tips" for
other possible causes.
1)
For alarm codes not described in the
table, contact an Authorised Service
Centre.
Possible solution
• The release quantity of rinse aid is too much. Adjust
the rinse aid selector to a lower position.
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient. Ad-
just the rinse aid selector to a higher position.
• The quality of the rinse aid can be the cause.
• The programme does not have a drying phase or has
a drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the multi-tablets can be the cause. Try a
different brand or activate the rinse aid dispenser and
use rinse aid and multi-tablets together.
Width / height / depth (mm) 596 / 850 / 610
Voltage (V)
Frequency (Hz)
Min. / max. bar (MPa)
Cold water or hot water
Place settings
Left-on mode (W)
Off-mode (W)
220 - 240
50
0.5 (0.05) / 8 (0.8)
max 60 °C
2)
15
0.99
0.10