Before First Use - AEG GS60BFSW Benutzerinformation

7. OPTIONS
7.1 Multitab
Activate this option when you use multi-
tablets that integrate the salt, rinse aid
and detergent functions. They can also
contain other cleaning or rinsing agents.
This option deactivates the release of
salt. The salt indicator does not come on.
With the use of this option the
programme duration is prolonged to
increase the cleaning and drying results
with the use of multi-tablets.
You do not need to activate the Multitab
option every time you start a
programme. Once you have activated
the option it will remain active.
How to activate Multitab
Press Option until the indicator
on.
7.2 TimeSaver
This option increases the pressure and
the temperature of the water. The
washing and the drying phases are
shorter.

8. BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
Desired options must be
activated every time before
you start a programme
(except for Multitab). It is not
possible to activate or
deactivate options while a
programme is running.
The total programme duration decreases
by approximately 50%.
The washing results are the same as with
the normal programme duration. The
drying results can decrease.
How to activate TimeSaver
Press Option until the indicator
comes on.
If the option is not applicable to the
programme, the related indicator does
not come on or it flashes quickly for a
few seconds and then goes off.
The display shows the updated
programme duration.
7.3 ExtraHygiene
With this option you have better hygiene
results. During the last rinsing phase, the
temperature stays at 70 °C for at least 10
minutes.
How to activate ExtraHygiene
Press Option until the indicator
comes on.
If the option is not applicable to the
comes
programme, the related indicator does
not come on or it flashes quickly for a
few seconds and then goes off.
The display shows the updated
programme duration.
detergent and do not load the
baskets.
When you start a programme, the
appliance can take up to 5 minutes to
recharge the resin in the water softener.
It seems that the appliance is not
working. The washing phase starts only
after this procedure is completed. The
procedure will be repeated periodically.
ENGLISH 73