Troubleshooting - Yamaha M-5000 Bedienungsanleitung

Refer to the table below if this unit does not function properly. If the instructions below do not help, or if the problem
you are experiencing is not listed below, turn off the unit, disconnect the power cord, and contact the nearest authorized
Yamaha dealer or service center.
Problem
Power does not turn
on.
The STANDBY/ON
indicator on the front
panel flashes.
The unit is turned on
but no sound is heard.
30

Troubleshooting

Cause
The power cord is not connected
to the AC IN connector on the
rear panel or is not plugged into
an AC outlet.
The protection circuitry has
been activated because of a
short circuit, etc.
The unit has been exposed to
a strong external electric shock
(such as lightning or strong
static electricity).
The protection circuitry has
been activated because of a
short circuit, etc.
There is a problem with the
internal circuitries of this unit.
The protection circuitry has
been activated because of a
short circuit, etc.
The SPEAKERS selector is set to
OFF.
The speaker cables are not
connected properly.
The INPUT selector setting does
not match the connected input
source.
Remedy
Connect the power cord firmly.
Make sure that the speaker wires are
not touching each other or shorting out
against the rear panel of the unit, and
then turn on the power to the unit.
Turn off the unit, disconnect the power
cord from the AC outlet, wait for about
30 seconds, and then plug the unit in
again.
Make sure that the speaker wires are
not touching each other or shorting out
against the rear panel of the unit, and
then turn on the power to the unit.
Disconnect the power cord from the
AC outlet and contact the nearest
authorized Yamaha dealer or service
center.
Make sure that the speaker wires are
not touching each other or shorting out
against the rear panel of the unit, and
then turn on the power to the unit.
Set the SPEAKERS selector to the
appropriate position.
Make sure that the speaker cables are
connected properly.
Select an appropriate input source with
the INPUT selector on the front panel.
See
page
24
16
24
16
24
16
6
16
12