Yamaha M-5000 Bedienungsanleitung Seite 19

MAL
3
Connect the power amplifier to the
speakers
For each channel speaker, connect the cables
from the speaker's mid/high range terminals
to the amplifier's SPEAKERS A jacks of the
corresponding channel, and from the speaker's
low range terminals to the amplifier's SPEAKERS
B jacks of the corresponding channel respectively.
4
Set the MODE selector on the rear panel to
NORMAL
5
Set the SPEAKERS selector on the front
panel to A+B BI-WIRING
M-5000
B
SPEAKERS selector
(front panel)
SPEAKERS
A
OFF B
+
A B
BI WIRING
L channel
L channel
High
Low
Remove the shorting bar
CAUTION
Be sure to use speakers that feature the impedance shown
in the table below .
Speaker impedance
SPEAKERS selector
Basic connection/
Bi-wiring connection
Bi-amp connection
Bridge connection
* Excluding models for U .S .A . and Canada
CAUTION
Before turning the power back on to the source component,
first lower the volume level on that component .
A B A+B
4Ω or higher 8Ω or higher
4Ω or higher 8Ω or higher
8Ω or higher 16Ω or higher*
19