Troubleshooting - Yamaha MCX-CA15 Bedienungsanleitung

Refer to the chart below if the MCX-CA15 does not function properly. If the problem you are experiencing is
not listed below or if the instruction below does not help, disconnect the power cord, and contact the nearest
authorized YAMAHA dealer or service center.
Problem
The AV link
technology
function does
not work
correctly.
The client does
not output any
sound.
Using the
MCX-CA15
produces
interference
noise on nearby
radios.
The STATUS
indicator on the
front panel of
the MCX-CA15
.
flashes rapidly
12

TROUBLESHOOTING

Cause
The signal is weak (for IR
flasher connections only).
The volume setting of the
client is low.
The speakers are not correctly
connected to the MCX-CA15.
The MCX-CA15 and the radio
are too close to each other.
The cables are not connected
correctly.
You are using low-impedance
speakers.
Remedy
Position the IR flasher so that it is
in clear view of the external
component's remote control
receiver.
Increase the volume setting.
Check the connections between
the speakers and MCX-CA15.
Place the MCX-CA15 and the
radio at least one meter apart.
Connect the cables correctly.
When using the MCX-CA15 in
the MusicCAST system, press
on the client for 10 seconds
to reset the system.
When using the MCX-CA15 as
an amplifier for another system,
press RESET on the inside front
panel of the MCX-CA15 to reset
this unit.
Use speakers with an impedance
Ω
of at least 4 .
When using the MCX-CA15 in
the MusicCAST system, press
on the client for 10 seconds
to reset the system.
When using the MCX-CA15 as
an amplifier for another system,
press RESET on the inside front
panel of the MCX-CA15 to reset
this unit.
Refer to
page
—
Quick
Manual,
page 9
Install
Manual,
page 11
—
11
11