Taking A Measurement; Memory Function - Braun ExactFit BP 4900 Gebrauchsanweisung

Display BP4900/BP5900
Low battery indicator
Date
Month
Irregular heart beat
symbol*
Morning
hypertension
symbol*
Heart rate symbol
Average symbol
Morning average record*
Evening average record*
* For BP5900 only
Note: On BP5900, the backlight goes on when the unit is turned on, buttons are pressed, or
when results are being displayed. It turns itself off after 10 seconds if no buttons are pressed.
6
Hour
Minute
Measuring
error display
Memory record
Fig. 9
Setting month, date and time
a. Press mode (5) button ("month" starts flashing)
Press set (4) button to set the correct month (1,2,3,...12)
b. Press mode (5) button ("date" start flashing)
Press set (4) button to set the correct date (1,2,3,...31)
c. Press mode (5) button ("hour" starts flashing)
Press set (4) button to set the correct hour (1,2,3,...12)
d. Press mode (5) button ("minute" starts flashing)
Press set (4) button to set the correct minute (0,1,2,3,...59)
e. Press mode (5) button again to lock in time settings. Digits will stop flashing.

Taking a measurement

Wrap the cuff around the arm (see "applying the arm cuff" section above).
1. Sit upright on the chair to have a correct posture.
2. Press the "start/stop " (1) button, all elements of the display indicate
"888" during the first 3 seconds. The measuring blood pressure symbol will
then flash on the display and the air pressure will automatically pump up
to certain pressure level and start measurement. (Fig.9 BP4900/BP5900)
Do not move or talk in the midst of taking blood pressure measurement.
3. After the air pressure has increased, it will slowly decrease. When the
pulse is detected, the heart rate symbol will start flashing.
After taking blood pressure measurement, the product will turn off
automatically after 1 minute.

Memory function

Your blood pressure monitor can store the latest readings of
48 measurements for BP4900, or 99 measurements for BP5900.
Storing measurement data
After each blood pressure measurement, the Systolic pressure, diastolic pressure, pulse rate
and the time & date of specific day will be automatically stored. Memory #01 is always the
most recent one. Once the memory is full, the oldest values will be overwritten.
Recalling stored readings
M
• Press "memory " (2) button, M:00 will appear on the display if there is no
data stored in the memory. If there is data stored in the memory, the latest
recorded set of measurement which is the systolic pressure, diastolic
pressure, pulse rate, and the recording time and date and M:01 will appear
on the display for 1 minute.
M
• Press the "memory " (2) button again to read the next line of stored data.
The data called up on the display with 2-digit memory number (ex. M:02).
7-day average function
Full day average
• Press the "average " (3) button once, "full day average" result will show
on LCD.
• Make sure the date / time is correct when taking measurement, so you
may get the correct 7-day average result.
• If there is no data in memory within past 7 days, " " will show on LCD.
7