Choosing Stimulation Intensity; Interrupt Application; Finishing Application; Commenting Feeling And Program - Saneo 4SPORT Gebrauchsanweisung

Choosing stimulation intensity

Take note of your own feelings!
You should clearly feel the current or stimulation
intensity but it should not be an unpleasant or painful
sensation at all.
The stimulation intensity for the individual channels A to D is
shown one below the other in the training screen (unit: mA).
Please choose the stimulation intensity with the buttons - / + on
the left and right of the respective channel indication on your
Smartphone.
→ Pressing the + button briefl y increases the stimulation intensity
by 1 mA for the relevant channel.
→ Pressing the - decreases the stimulation intensity by 1 mA for
the relevant channel.
The treatment starts.
The remaining time of treatment is indicated.
If a suitable stimulation intensity was adjusted and not changed
for 15 seconds, the display gets grey and consequently locked.
The keypad is secured. Only the stop button is still usable.
→ Unlock the display if needed by simply stroking the writing
„unlock", e.g. to edit the intensity.
Observe the safety notes!
Please check if your general health situation allows or
limit the application of the system.
Treatment frequency
As long as side effects like e.g. skin irritations do not
occur, you can do several treatments daily if required.
Please note that a program can only be changed if
the program operation has been stopped before. To
change the program during the ongoing operation change the program during the ongoing operation the
program has to be stopped with the button
Operating the Saneo 4 SPORT

Interrupt application

An application can be interrupted at any time by clicking on the An application can be interrupted at any time by clicking on the
Stop button . While the application is stopped, the mA number . While the application is stopped, the mA number
can not be changed. After clicking on the start button
application will continue with the same settings as before the
interruption. Due to safety reasons, the current is now regulated
slowly and delayed up to its original setting.
By holding down the ON / OFF switch on the bodypack, the appli-
cation can also be stopped. Note, however, that this completely
breaks off the connection between bodypack and smartphone.

Finishing application

After expiration of the training time the App automatically chan-
ges into the evaluation screen. An application can be abort at any
time with the stopp button.
→ Entfernen Sie die Elektrode(n) erst, wenn alle laufenden Pro-
gramme beendet sind und Sie sich nicht mehr im Programm-
menü befi nden.

Commenting feeling and program

If you use a TENS program, the query of your current pain level
on a scale between 0 and 10 occurs again (0 = no pain, 10 =
strong pain).
In the following you can indicate your feeling of the training as
well as give an personal comment of the special training in the
appropriate text fi eld.
Finally click on „Continue". Your application with all details was
saved in your diary.

Cleaning electrodes

→ Clean the electrodes after each use as described in the chap-
ter Care & Disposal.
If the adhesion of the electrodes decreases, moisten
the adhesive surface with some water and store them
.
in a cool place (e.g. the refrigerator) until the next
application. Only if this does not show any effect any
more, the electrodes have to be exchanged..
E
, the
45