Installing/Replacing Activated Charcoal Filters (Only For Circulation Air Operation); Circulation Air Operation - Privileg SY-103D1-E3-C25-L12-900 Gebrauchsanleitung

4. Wash grease filters in a dishwasher or in
the sink like ordinary crockery.
5. Allow grease filters to dry completely.
6. Reinsert the grease filter. To do this, insert
the grease filter in the top of the recess:
Slide the lock upwards, press down on
the grease filter and release the lock. The
grease filter engages.
7. Reconnect the power supply.
8. To close the flap 14 of the exhaust hood
1: press the button 13
Installing/replacing activated
charcoal filters (only for

circulation air operation)

The activated coal filters remove odours.
They have to be replaced as soon as the
cooking odours can no longer be adequately
filtered. If used frequently, the filters should be
replaced regularly (check every 6 months).
1. To open the cover 14 of the exhaust hood
1 upwards, press the button 13
seconds.
2. Once the cover has reached the highest
position: Unplug the mains plug or switch
off the power to the corresponding main
fuse.
3. Slide the grease filter lock 8 sideways and
carefully remove the grease filter by pull-
ing upwards.
4. To replace: Turning them clockwise, un-
(for 3 seconds).
5. Fit the activated charcoal filters
for 3
6. Reinsert the grease filter. To do this, insert
7. Reconnect the power supply.
8. Close cover 14 by pressing the button 13
Care and maintenance
screw both activated charcoal filters 5
to the right and left of the motor and
remove them. You can dispose of them
with household waste.
and left of the motor and tighten them by turn-
ing them anticlockwise, allowing the locks to
click into place.
the grease filter in the top of the recess:
Slide the lock upwards, press down on
the grease filter and release the lock. The
grease filter engages.
(for 3 seconds).
Page EN-11
5
5 to the right