Daily Maintenance - Husqvarna FS 3500 G Bedienungsanweisung

• Always park the machine on a level surface with the engine OFF and the Engine start switch set in the STOP position before
performing any maintenance. Press the Machine stop on the control panel.
Please read the engine manual for your machine carefully and make sure you understand the instructions before using the
machine. There are some maintenance intervals specified in the engine manual.

Daily maintenance

Daily maintenance must also be carried out after transportation.
Check for fuel and oil leakage.
Check the engine's oil level
Check blade guard for damage
Check hoses and clamps for damage or
looseness. Tighten or replace as
required.
Check air cleaner restriction indicator.
Clean outer air filter if indicator is red.
Make sure all safety guards are in place
and in good condition.
Check the water spray over the diamond
blade.
Replace engine oil and filter*
Lubricate front wheels
Lubricate blade shaft (2 pumps each end)
Check the drive belt for wear.
Replace engine oil and filter*
Lubricate front axle pivot bearings
Check wheels for wear or damage.
Check rear wheels for looseness
Check engine air cleaner hose and
clamps
Check hydraulic system fluid level
Lubricate hydraulic cylinder pivot pin.
Lubricate rear axle bearing.
Replace hydraulic system fluid
Replace engine fuel filter (spin-on-type)
Replace outer and inner air filter
* Once at 50h then every 100h
26 –
English
MAINTENANCE AND SERVICE
Daily 50h
X
X
X
X
X
X
X
X
X
X
X
100h 250h 500h
X
X
X
X
X
X
X
X
X
X
Yearly
X