Before Starting; Starting For The First Time; Starting And Stopping; Starting - Husqvarna FS 3500 G Bedienungsanweisung

Before starting

WARNING! Please read the operator's
manual carefully and make sure you
understand the instructions before using the
machine.
Wear personal protective equipment. See
instructions under the "Personal protective
equipment" heading.
Make sure no unauthorised persons are in
the working area, otherwise there is a risk of
serious personal injury.
• Perform daily maintenance. See instructions in section
"Maintenance and service".
• Check that the blade is not in contact with anything when
the machine is started.
NOTICE! Read the operator's manual supplied by the
engine manufacturer.
Starting for the first time
• Check engine oil level without blade and the saw
horizontal for a flat saw level.
• Connect battery cables. The floor saw unit is supplied with
no battery cables connected.
For some markets batteries are not supplied due to safety
reason during transportation. Install a new battery.
For more information, see the "Technical data" section.
This machine is equipped with a fuel shut-off valve. To start
the machine the first time:
• Fill the fuel reservoir.
• Remove the rear protective cover and open the fuel shut-
off valve.
• Reinstall the rear protective cover.
22 –
English

STARTING AND STOPPING

• Lower the front guide and align the front guide, rear guide
and the diamond blade with the line on the surface. The
front guide is telescopic, adjust the length with the screws
on the inside of the front guide.

Starting

• Connect the machine to a water supply. Turn off the Water
valve.
• Mark the surface to be cut by drawing a line where the cut
is to be made.
• Pull out handle bars to desired length and height and
tighten the knobs.

Start the engine

• To start the saw when no water pressure is present, set
the Water safety switch to the OFF position.
B
A