Moving The Machine - Husqvarna FS 3500 G Bedienungsanweisung

• Turn handle adjustment locking knob B counterclockwise
to unlock and reposition handlebar. Turn clockwise to lock
handlebar in position. Set handle to most comfortable
working height. Tighten the locking knob.

Moving the machine

Prior to moving the machine, read and understand section
"Starting and stopping".
Moving the machine with the engine off
• Turn Engine start switch to "RUN" position.
Raise the saw by pressing up the Raise/lower switch on the
Forward/Reverse control lever until the blade (if installed)
clears the pavement surface.
• Put Forward/Reverse control lever into the Stop/Neutral
position.
• Turn the locking knob counterclockwise to unlock and
reposition the freewheel into transport mode. Tighten the
locking knob.
16 –
English
OPERATING
B
A
• Raise the saw until the two rear wheels clears the surface.
The saw can now be moved by standing behind it and
pushing (while holding the handlebars).
WARNING! Do not attempt to push the saw
with engaged transport wheel on a grade (or
hill). The saw operator could lose control of
the saw and cause injury to oneself or other
persons in the area.
Moving the saw with the engine on
• Raise the saw by pressing up the Raise/lower switch on
the Forward/Reverse control lever until the blade (if
installed) clears the pavement surface.
WARNING! Never transport the machine
outside the cutting area with engine on and
with a blade installed.
• Set the Water safety switch to the OFF position.
• Put the Forward/Reverse control lever into the Stop/
Neutral position. The engine will not start unless the lever
is in the Stop/Neutral position.