Engine Will Not Start; Trouble Shooting Guide - Husqvarna FS 410 D Bedienungsanweisung

Engine Will Not Start:

Electrical switches not in correct position.
Fuel valve closed.
Choke valve open.
Fuel tank empty.
Contamination, or water ice in fuel system.
Buildup on spark plug electrodes.
Engine has no power or runs unevenly. Air filter Clogged.
Diamond Blade Trouble Shooting:
Problem
Loss of Tension in Diamond Blade
Segment Loss
Cracked Blade Core
Cracked Blade Segments

TROUBLE SHOOTING GUIDE

Cause
Blade being used on misaligned saw. Check for proper saw alignment.
Blade is excessively "hard" for material being cut, creating stress on steel blade
center. Check that blade is correct for material being cut.
Different diameter or undersize blade flanges creates uneven pressure on blade
center. Use proper size flange on each side of blade. Never use worn or dam-
aged flanges.
Blade operated at improper speed (R.P.M.). Make certain blade shaft is turning at
the proper speed (R.P.M.) for blade size. Check R.P.M. using a tachometer.
Blade improperly mounted on arbor. Could become bent when flanges are tight-
ened.
Blade is too "hard" for material being cut. Use "softer" blade specification.
Overheated blade, detected as "blue" color on steel center. Check that water
supply is adequate and not blocked.
Saw is twisted while cutting. Saw only in a straight line.
Blade Bore is worn to an eccentric shape (ovalized). Replace worn blade and
worn spindle.
Segment knocked off during mounting our transport. Avoid rough handling of
diamond blade. Never transport the machine with the diamond blade mounted.
Blade is too "hard" for material being cut. Use "softer" blade specification.
Overheated blade, detected as "blue" color on steel center. Check that water
supply is adequate and not blocked.
Saw is twisted while cutting. Saw only in a straight line.
Blade is too "hard" for material being cut. Use "softer" blade specification.
Blade operated at improper speed (R.P.M.). Make certain blade shaft is turning at
the proper speed (R.P.M.) for blade size. Check R.P.M. using a tachometer.
Check that BOTH Machine Stop (AA) and Engine
Start Switch (DD) are in "ON" position. Machine Stop
(AA) should be pulled outward from cowl, and Engine
Start Switch (DD) turned to "1" (ON) position.
Open the fuel valve.
Close the choke with cold engine.
Fill with fuel.
Clean tank, fuel lines and carburetor. Fill tank with fresh fuel.
Check electrode gap and clean.
Clean or replace the air filter.
Cause & Action
WARNING!
DO NOT use damaged diamond blades!
Death or injury could occur if machine is op-
erated using damaged diamond blades!
Action
29