Verdampferbehälterabdeckung; Installation; Mounting The Combi Heater - Sawotec SAVONIA COMBI Bedienungsanleitung

Verdampferbehälterabdeckung
Abb 5
Steamer Cover
Fig. 5
Anbringen der Verdampfer-
abdeckung
Attach the steamer cover
as shown
1.
Drücken (erst loslassen,
wenndie Abdeckung voll-
ständig befestigt ist)
Push (don't release until
steamer cover is fully
attached)

INSTALLATIoN

mouNTINg THE CombI HEATER

• It is recommended that the Combi Heater is placed on the floor nearest to the
door.
• For safety and convenience, follow the minimum safety distances as provided in
Follow the cubic volumes given in page 29.
• Do not install the heater on a niche in the wall.
• Do not install more than one heater, unless, you follow the special instructions for
twin-heater installations.
• In most countries, there is a law that requires heaters to be screwed on the floor
as provided in page 10.
• A Combi Heater, when used, is naturally hot. To avoid accidental contact with the
surface of the Combi Heater, it is necessary to affix a heater guard. Figure 4 shows
the minimum safety distances in installing heater guards.
NoTE: Remove the packaging from the heating elements before installing the heater as
it is only intended to protect them during shipment. Make sure the Silica gel packs are
still attached to the packaging, as the purpose of those packs is to remove the moisture
during shipment.
Abb 6 Minimum Safety Distances (mm)
Minimale Sicherheitsabstände (mm)
Fig. 6
MIN. 110
110
MIN.
70
MM
SAVC-90NS
2. Nach unten drücken
Push down
3. Die Verdampferabdeckung
nach unten unter den Rahmen
drücken
Push the steamer cover
down below the frame
Rahmen
Frame
4.
Nach innen schieben
Slide inward
MIN. 120
120
MIN.
70
MM
SAVC-105NS
Abnehmen der Verdampferabdeckung
Remove the steamer cover as shown
2. Nach unten drücken
Push down
1.
Anheben
Lift up
MIN. 130
130
MIN.
70
SAVC-120NS
3.
Herausziehen
Pull out
MIN. 160
MIN.
MM
SAVC-150NS
SAVC-180NS
ENGLISH
11