Replacement Of The Connection Cable - AEG HC411520GB Benutzerinformation

Replacement of the connection cable

In order to replace the connection cable speak your local Service Force Centre!
To replace the connection cable use only H05BB-F Tmax 90°C (or higher) type. Make sure
that the cable section is applicable to the power and the working temperature. The yellow/
green earth wire must be approximately 2 cm longer than all phase wires.
Assembly
min.
50mm
R 5mm
490
• Seal the gap between the worktop and glass ceramic with silicone.
• Put some soapy water on the silicone.
• Pull off the excess silicone with the scraper.
min.
650mm
min.
450mm
600mm
mm
+1
340 mm
+1
Installation
min. 20 mm
27
min.
30 mm