UCOM Twintalker 6800 Motorpack
12.8 Monitor
You can use the MONITOR feature to check for weaker signals in the current channel.
In power-on mode:
•
Press the
- button
monitoring. Hold these buttons for 3 seconds for continuous monitoring.
•
Press the
12.9 VOX Selection
The PMR is capable of voice activated (VOX) transmission. In VOX mode, the radio will
transmit a signal when it is activated by your voice or other sound around you. VOX operation
is not recommended if you plan to use your radio in a noisy or windy environment.
In power-on mode:
•
•
•
When no button is pressed within 7 seconds during setting, the
unit will return to stand-by.
12.10 Channel Scan
Channel scan performs searches for active signals in an endless loop from channel 1 to 8.
In power-on mode:
•
•
•
•
•
•
34
and the
- button
to stop monitoring.
Press the
- button
the display and the VOX-icon is displayed.
Press the
- button
- button
again to select the VOX sensitivity level between 1 to 3,
which is indicated in the right corner of the display. Press the
button
until 'OF' appears on the display, to turn VOX off.
Press the
- button
stand-by mode.
Press and hold the
start scanning.
When an active signal (one of 8 channels) is detected, press the
- button
Channel scan pauses and you will hear the active signal.
When the active channel is not fixed by pressing the
, channel scan will automatically continue when there is no more
activity on the channel.
If the channel is fixed by pressing the
restart scanning by pressing the
.
If the channel is not fixed by pressing the
restart scanning immediately by pressing the
- button
.
Press the
- button
- button
simultaneous to activate channel
3 times. The actual VOX setting flashes in
to turn the VOX feature ON. Press the
to confirm your selection and return to
- button
. Press the
to fix and communicate through the active signal.
to deactivate channel scan.
- button
- button
, you can
- button
or the
- button
- button
UCOM Twintalker 6800 Motorpack
-
to
- button
- button
, you can
or the