Stopwatch; Adjusting Speaker Volume; Receiving A Signal; Transmitting A Signal - UCOM Twintalker 6800 Gebrauchsanweisung

UCOM Twintalker 6800 Motorpack
NOTE!
• When no button is pressed within 7 seconds during setting, the unit will return to
stand-by.
• The time will be reset to 12:00 when the battery is removed.

12.2.2 Stopwatch

In power-off mode:
• Press and hold the
• Press the - button
• Press the - button
• Press the - button
• Press and hold the

12.3 Adjusting Speaker Volume

In power-on mode:
•
•
The Speaker Volume level is displayed on the LCD during setting.

12.4 Receiving a Signal

The unit is continuously in the receive mode when the unit is switched on
and not transmitting.
When you receive a signal on the current channel, the RX icon is
displayed.
NOTE!
In order for other people to receive your transmission, they must be set on the same chan-
nel and CTCSS code (See chapter 12.6 and 12.7)

12.5 Transmitting a Signal

In power-on mode:
•
•
•
Any PMR set on the same channel can receive and listen to the conversation.
You have to wait until the opposite site stops talking before you can answer the message.
At the end of each transmission, the device will transmit a beep.
32
- button
to start counting
to stop counting
to reset the timer
- button
Press the - button
Press the - button
Press and hold the
displayed.
Hold the unit in a vertical position with the MICROPHONE 5 cm from
the mouth and speak into the microphone.
Release the - button
for 3 seconds to enter stopwatch mode
for 3 seconds to exit stopwatch mode
to increase the speaker volume.
to decrease the speaker volume
- button
when you have finished transmitting.
to transmit. The TX-icon is
UCOM Twintalker 6800 Motorpack