Mode Menu; Units Menu - OHAUS Navigator NV622 Bedienungsanleitung

TM
Navigator
4.3 Setup Sub-Menu
The backlit LCD display will have different menu items or settings based on the functionality.
 Auto Off [A-Off] (on, off) - When Auto Off is set to "on" the balance will turn off automatically
after 5 minutes of inactivity. Auto off is used to save battery power.
 Display [disply] (on, auto, off ) - This setting controls the LCD backlight; constant on,
automatic turn off after 5 seconds of balance inactivity, or always off.
 IR Sensor [Ir.Func] (Off, Tare, Function, Print, Zero, Display) - These settings determine the
role of the IR Sensor. "Zero", "Print", "Function" or "Tare" allows the IR sensor to act the same
as the related button. "Display" activates the display if Display-Auto is set. "Off" disables the
sensor.*
*Availability of IR Sensor is dependent on model and region.

4.4 Mode Menu

This sub-menu activates modes so they will be available for use with the Mode button. Weigh mode is
always active.
 Parts Count [Count] (on, off) - Set on for the mode to be active.
 Percent [Percnt] (on, off) - Set on for the mode to be active.
 Check Weigh [CHECk] (on, off) - Set on for the mode to be active.

4.5 Units Menu

This sub-menu activates units so they will be accessible with the Units button. The units in the menu
must be turned "on" to be active.
Note: Available units and modes vary by model and local regulations.
4.6 Sealing access to balance settings
The Menu Lock switch limits changes to the Cal, Setup, Mode and Unit menus. The switch in type
approved models may set some balance settings as required by the approval agency. The switch may
be secured using paper seals, wire seals or plastic ties.
Locked
EN-7
Unlocked