Definition Of Signal Warnings And Symbols; Safety Precautions; Intended Use - OHAUS Navigator NV622 Bedienungsanleitung

TM
Navigator
1. INTRODUCTION
This manual contains installation, operation and maintenance instructions for the Navigator
Please read the manual completely before using the balance.

1.1 Definition of Signal Warnings and Symbols

WARNING
CAUTION
Attention
Note

1.2 Safety Precautions

CAUTION: Read all safety warnings before installing, making connections, or servicing
this equipment. Failure to comply with these warnings could result in personal injury
and/or property damage. Retain all instructions for future reference.
 Verify that the AC adapter's input voltage range and plug type are compatible with the local AC
mains power supply.
 Position the instrument such that the AC adapter can be easily disconnected from the wall socket.
 Position the power cord so that it does not pose a potential obstacle or tripping hazard.
 Operate the equipment only under ambient conditions specified in these instructions.
 The equipment is for indoor use only.
 Do not operate the equipment in hazardous or explosive environments.
 Only use the equipment in dry locations.
 Only use approved accessories and peripherals.
 Disconnect the equipment from the power supply when cleaning.
 Service should only be performed by authorized personnel.

1.3 Intended Use

Use the instrument exclusively for weighing as described in the operating instructions. Any other type
of use and operation beyond the limits of technical specifications without written consent from OHAUS,
is considered as not intended. This instrument complies with current industry standards and the
recognized safety regulations; however, it can constitute a hazard in use. If the instrument is not used
according to these operating instructions, the intended protection of the instrument may be
compromised and OHAUS assumes no liability.
For a hazardous situation with medium risk, possibly resulting in
injuries or death if not avoided.
For a hazardous situation with low risk, resulting in damage to the
device or the property or in loss of data, or injuries if not avoided.
For important information about the product
For useful information about the product
General hazard
Electrical shock hazard
EN-1
Series.
TM