Setting The Time; D) Setting The Electricity Tariff - VOLTCRAFT ENERGY-MONITOR 4500ADVANCED Bedienungsanleitung

c) Setting the time
• As described in section b), hold the "SET" button (1) pressed for approx. 3 seconds to start
the set-up mode. "
appears in the upper display for the currently set time display format.
The set-up mode can be closed early by pressing the "SET" button (1) again for approx.
3 seconds. The settings made are saved.
• Press the "SET" (1) button briefly until "12" or "24" flashes in the display.
• Select the 12h or 24h mode for the time display using the "
If the 12h format is used, "PM" appears in the display on the right next to the time during the
second half of the day.
• Briefly press the "SET" (1) button, the hours of the displayed time flash.
• Set the hours with the "
• Briefly press the "SET" (1) button, the minutes of the displayed time flash.
• Set the minutes with the "
• Briefly press the "SET" (1) button to confirm; the time display will stop flashing.
• When the time display no longer flashes, you can proceed to setting the electricity tariff (see
next section) by briefly pressing the "
press the "SET" button (1) and proceed as described above.
If you want to close the set-up mode, hold the "SET" button (1) pressed for 3 seconds
(or do not press a button for one minute).

d) Setting the electricity tariff

• If you have set the 12h/24h format and the time (see section c) before setting the electricity
tariff, you can proceed directly with the next step.
Otherwise, the set-up mode must be started by pressing the "SET" button (1) for approx.
3 seconds. "
in the upper display. By briefly pressing the "
for the first electricity tariff, see next step.
" will be shown in the top left of the display and "24R" (or "12HR")
" (4) or "
" (4) or "
" will be shown in the top left of the display and "24Hr" (or "12Hr") appears
" (5) button.
" (5) button.
" button (5). If you want to correct the time, briefly
" button (5) button, you proceed to the set-up
" (4) or " " (5) button.
37