E) Setting The Ghg/Co Emission - VOLTCRAFT ENERGY-MONITOR 4500ADVANCED Bedienungsanleitung

e) Setting the GhG/CO
Here, you can enter the CO
respective electricity tariff (for example 0.480 kg/kWh) from the internet page of your electricity
company or maybe from the contract documents of your electricity tariff.
Our tip:
If you have an electricity tariff with 100% electricity from sustainable resources, entering
0.000 kg CO
You can enter a value for CO
ing device shows how much CO
sustainable resources as electricity company.
Depending on the power input, the measuring device will show the respective CO
created during the operation of the connected load.
• If you have set the electricity tariff (see section d) before setting the CO
proceed directly with the next step.
Otherwise, the set-up mode must be started by pressing the "SET" button (1) for approx.
3 seconds. "
pears in the upper display. Press the "
settings, see next step.
• "GHG/CO " appears in the bottom left of the display, the CO
2
electricity tariff can now be entered.
• Briefly press the "SET" (1) button, the first position of the CO
Change the numeric value of the flashing input position with the "
button.
Briefly press the "SET" (1) button to activate the next input position.
After confirming the last input position, the display stops flashing.
• By briefly pressing the "
section f). If you want to correct the CO
and proceed as described above.
If you want to close the set-up mode, hold the "SET" button (1) pressed for 3 seconds
(or do not press a button for one minute).
40
emission
2
emission per kWh. You can find the value applicable to your
2
/kWh does not make sense.
2
emission of a normal electricity tariff. Then, the measur-
2
" will be shown in the top left of the display and "24Hr" (or "12Hr") ap-
" button (5), you can set the alarm for overloading, see next
is saved by preferring a provider of energy from
2
" button (5) briefly 2x to open the CO
emission settings, briefly press the "SET" button (1)
2
emission, you can
2
emission per kWh of your
2
emission flashes.
2
" (4) or "
emission
2
emission
2
" (5)