Processing Of A Route - KLEIBER KG 315-K USB Betriebsanleitung

SET[
will be
It is also possible to move measuring points over the edge of the Grid. They are inserted on the opposite side.
It follows the selection of the Dynamic Y. This is set as the Dynamic X, if it exists.
Selection of the program sequence
When creating Ways is it possible to set for each Route a following Route. After completion of the selected
Route the following Route can automatically started with the same features (Options, Dynamics, when possi-
ble). When no following Route is set no starts.
following Route) and
By pressing the button SELECT , the Route with the selected properties will be started.

6.3.3 Processing of a Route

Once a Route has been started, all points will be displayed one after one. At any point the following actions
are possible:
• By pressing the two step button to the first position the currently measured temperature is displayed.
• By pressing the two step button to the second step the currently measured temperature will be saved, if
it occurs in the selected boundaries. The measured temperature will be shown, until the two step button
was pressed to the first position. Then, the next point is automatically selected. If the temperature of the
last point is recorded, the menu "Route done" will be called.
• By pressing the button – the previous point can be selected if available.
• By pressing the button +
measured, the output will be 0, independent from the selected degree. If is it already the last one, the
menu "Route done" will be called.
• By pressing the button COM the menu "Route abort" will be called.
• By pressing the button INIT date and time can be displayed in the same manner as described in Date
display at the measuring point display / override of the measuring points (section 6.2.3) at page 15, when
a temperature is already saved.
Menu Route done
ProG
Between
ing the button SELECT
KG 315 - K USB
(Flue5 Wall A).
PrFo
(every following Route as long as available) are the choices.
the next point to be selected. For every point where no temperature was
(Route done) and
and the selection "Route done", the Route will be saved and an possible following
PrFo
(no following Route),
ProG
(Route not done) can be chosen. By press-
6 Recording modes
PrFo
(one
19