Data Transmission To Pc; Configuration; Selection Of Values; Parameters - KLEIBER KG 315-K USB Betriebsanleitung

5 Operation
0
Display:
After clearing, by pressing SELECT , the recording mode will continue.

5.2.6 Data transmission to PC

Using the software KG 315 - K USB Pyroskop Control included with the infrared interface, it is easily possible
to read out the measured data. For this purpose the positioning pins of the infrared interface are inserted into
the positioning aids on the pyrometer.
It is important to ensure that the chamfered side of the interface shows up. The USB connector is connected
to a free USB port on the PC.
The Software KG 315 - K USB Pyroskop Control is explained in a separate manual.
5.3 Configuration

5.3.1 Selection of values

The configuration menu is displayed from measuring mode by pressing CONF
ously.
In this menu the SELECT
pressing the + or – key. The displayed value will be enlarged or reduced by one step.
If one of the two keys is pressed longer than two seconds a quick-count mode will be set to allow the change
of values more quickly.
By pressing the SELECT key the value will be stored in the correct limits and the next menu item is selected..

5.3.2 Parameters

1. Emissivity
The emissivity can be chosen between 0.1 and 1.00.
2. Maximum temperature (only Classic Extended, Ways)
The maximum temperature can be set.
3. Minimum temperature
The minimum temperature can be set.
4. Energy saving mode
The time until energy saving mode is reached.
10
after a few seconds
Figure 4: Position of the infrared interface for data transfer
key switches to the next menu point. The selection of values can be done by
0
and SELECT simultane-
KG 315 - K USB