D
Vormontierte Rollenumlaufeinheiten einbauen
Zweiteilige Verschlusskappe aus Stahl (KA-ST/A) montieren:
■
Alu-Andruckring
in die Bohrung einlegen.
■
Verschlusskappe aus Stahl (KA-ST/A)
der Bohrung fixieren.
■
Anschließend mit der Montagevorrichtung MVH.TSX
bündig einpressen, Seite 16.
■
Montagevorrichtung MVH.TSX an Hydraulikversorgung
anschließen, und Entlüftung
Die Zweiteilige Verschlusskappe aus Stahl (KA-ST/A)
kann nur auf die Führungsschiene TSX..-KA+ST montiert
werden!
Fitting of preassembled linear roller bearing and
guideway assembly
Fit the two-piece closing plug made from steel (KA-ST/A):
■
Insert the aluminium clinch ring
■
Locate the closing plug made from steel (KA-ST/A)
in the hole by hand.
■
Press the closing plug in flush using the fitting device
MVH.TSX
, page 16.
■
Connect the fitting device MVH.TSX to the hydraulic supply
and ensure that it is vented
The two-piece closing plug made from steel (KA-ST/A)
can only be fitted to the guideway TSX..-KA+ST.
mit der Hand in
sicherstellen.
in the hole.
.
4
3
2
1
5
15