Renishaw RMP600 Schnellstartanleitung Seite 29

1
Key to the symbols
LED short flash
LED long flash
Deflect the stylus for less than 4 seconds
to move to the next menu option.
Deflect the stylus for more than
4 seconds to move to the next menu.
To exit, leave the stylus untouched for
more than 20 seconds.
CAUTION: Do not remove the batteries whilst in
configuration mode. To exit, leave the stylus untouched
for more than 20 seconds.
Placing the probe in configuration mode
2
> 5 s
3
LED check

Deflect the stylus and hold it
deflected until after the battery
status has been displayed at the
end of the review sequence.
Battery status
Battery good
or
To change the switch-on method,

Battery low
go to the next page.
1-23