Werbung
SIGNAL LED / PEAK LED
Signal (green) shows the presence of any input signal
(>20dBu). Peak (red) shows an overload condition (distortion).
In this case, check the GAIN setting and the setting of the
channel EQ.
PFL (momentary switch per input channel )
Sends the channel signal to the PFL level indicator and to the
built-in stereo headphone amplifier output socket.
Normally, the PFL indicator will read approx. 0dB. Extremely
high output levels will cause audible distortion (clipping). Check
all input channels by pressing the PFL button and by reading
PFL indicator. Correct TRIM control setting if necessary.
FADER (Channel Fader)
The slide potentiometer works in conjuction with the TRIM
Control to adjust the gain for that input channel (mic & line
inputs). Depending on the signal present, the normal operating
position will be at the '0' mark. (Max headroom = +6dBu)
MASTER SECTION
MASTER FADER LEFT / RIGHT
These faders control the overall output level towards the Left
Out and Right Out sockets.
They also control the output of the internal power amplifiers,
when the power rouiting selector switches are set to L&R
Controls the overall output level of all MON signals coming
from the input channels. (output via MON mono jack socket).
The monitor fader will also control the internal power
amplifiers, when the Power Routing switches are in MON
position.
20
position.
AUX1 SEND (Master Control)
Controls the overall output
level of all AUX1 signals
coming from the input
channels. (output via AUX1
Send mono jack socket)
AUX2 SEND (Master Control)
Controls the overall output
level of all AUX2 signals
coming from the input
channels. (output via AUX2
Send mono jack socket)
MONITOR FADER (Master)
Werbung
