Werbung
XRL (female) MIC INPUT
Use this input for low impedance balanced microphone
connection.
XLR socket/plug wiring:
1=shield, 2=hot (+), 3=cold (-)
When using unbalanced signals, a wire bridge must be
inserted into the incoming XLR/m connector from pin 1 to 3.
Phantom Power (+48V) (switch with LED indicator )
When using phantom powered condenser microphones, switch
‚Phantom Power' ON. Channel fader should be down, when
operating phantom power switch.
When using only dynamic microphones, phantom power should
be in 'OFF' position.
Line Input Jack Sockets (mono channels 1-6)
These channels are for use with monaural line signals such as
musical instruments. (Line input amplification is 22dB below the
GAIN setting).
Stereo Input channels 7/8 and 9/10
Via Jack Sockets L/R, these channels may be used either as
mono- or stereo channels. (Selector switch in position A)
The RCA inputs L/R are for use with stereo line signals only and
will be activated by setting the selector switch to position B)
HPF (High Pass Filter)
Channels 1-6 feature a High Pass Filter which will help to
dampen resonances below 100Hz (-12dB/oct.) HPF should be
used with vocal microphones etc.
GAIN
The GAIN control matches the incoming Signal to the required
mixing levels.
18
Werbung
