Operation - ratiotec Rapidcount S 60 Bedienungsanleitung

Operation

12
1. Connect the power cable and switch on the machine.
The machine now carries out a self-test sequence.
A "0" appears on the display. Should a different symbol
appear, please refer how to proceed under "Trouble-
shooting".
2. To avoid error messages and damages to the sensors,
any severely damaged and dirty bank notes should be
sorted out now.
3. Set the bank-note feeder to the width of the bank notes
to be counted.
Slightly fan out the bank notes as shown in the figure.
4.
Lay a pre-sorted stack of bank notes (e.g. only 20 Euro
bank notes) in the bank-note feeder. The machine starts
the counting process automatically and shows the
counted piece number on the display. If the total-value
count mode is activated on rapidcount S 85 then bank
notes can be placed unsorted (mixed) on the banknote
feeder. The machine shows the total value of the notes.
If total-value count mode is deactivated, the piece
number will be displayed. The S 60 model detects smal-
right
ler bank notes if IR or MG detection is activated (up to
100 Euro) in a stack. The first bank note that is drawn in
is always used as reference. Whenever a smaller bank
note is detected, the machine stops automatically (Er-
ror "Ed"). The S 85 model detects smaller and larger
wrong
bank notes in a stack whenever authenticity detection
and total-value count are activated. The first bank note
that is drawn in is used as reference. If a bank note with
a different format is detected the machine stops auto-
matically (Error "F-P").
5. The sensitivity DEN should always stand on 2 in the
case of Euro bank notes. (factory setting)