Replacing The Lamp; Closing The Door - Electrolux FI5004NA+ Benutzerinformation

Problem
Water flows inside the re‐
frigerator.
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.

7.2 Replacing the lamp

The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
Possible cause
Food products prevent
the water to flow into the
water collector.
The water outlet is clog‐
ged.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
There is no cold air circu‐
lation in the appliance.
1. Disconnect the mains plug from the
2. Remove the lamp cover (refer to the
3. Replace the used lamp with a new
4. Connect the mains plug to the mains
5. Open the door. Make sure that the

7.3 Closing the door

1. Clean the door gaskets.
Solution
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Make sure that there is cold
air circulation in the appli‐
ance.
CAUTION!
Disconnect the plug from the
mains socket.
mains socket.
illustration).
lamp of the same power and
specifically designed for household
appliances. The maximum power is
shown on the lamp cover.
socket.
lamp lights up.
ENGLISH 13