Electrolux FI5004NA+ Benutzerinformation Seite 12

12 www.electrolux.com
7.1 What to do if...
Problem
The appliance does not
operate.
The Alarm light flashes
The appliance is noisy.
Audible or visual alarm is
on.
The compressor operates
continually.
There is too much frost
and ice.
Water flows on the rear
plate of the refrigerator.
Possible cause
The appliance is switch‐
ed off.
The mains plug is not
connected to the mains
socket correctly.
There is no voltage in the
mains socket.
The temperature in the
freezer is too high.
The appliance is not sup‐
ported properly.
The cabinet has been re‐
cently switched on or the
temperature is still too
high.
The temperature in the
appliance is too high.
The temperature in the
appliance is too high.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The door is not closed
correctly or the gasket is
deformed/dirty.
During the automatic de‐
frosting process, frost
melts on the rear plate.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock‐
et. Contact a qualified elec‐
trician.
Refer to 'High temperature
alarm.
Check if the appliance
stands stable.
Refer to "High temperature
alarm".
Refer to "High temperature
alarm".
Contact a qualified electri‐
cian or contact the nearest
Authorised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "Closing the door".
This is correct.