Replacing The Lamp; Installation - Electrolux SB315N Benutzerinformation

56 www.electrolux.com
Problem
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap-
pliance is too low/too high.

6.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.

7. INSTALLATION

7.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
WARNING!
Refer to Safety chapters.
Possible cause
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The FROSTMATIC or
COOLMATIC function is
switched on.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The FROSTMATIC func-
tion is switched on.
The COOLMATIC function
is switched on.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Climate
class
SN
N
ST
T
Solution
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC or
COOLMATIC manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FROST-
MATIC or COOLMATIC func-
tion".
Set a higher/lower tempera-
ture.
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Refer to "FROSTMATIC func-
tion".
Refer to "COOLMATIC func-
tion".
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C