Fitting The Plinth - Electrolux FI5004NA+ Benutzerinformation

1
2
5. Close the door and check that the
small door is positioned at the
required height, operating the
adjustment screws if necessary.
6. Use the same screws for vertical
alignment of the small doors.
7. If necessary, carry our horizontal
alignment by shifting the small doors.
8. After aligning the doors, tighten the
nuts of the brackets and the screws
of the small bracket.
9. Fix the shorter and longer bracket
located under the door to the panel
with the two plastic washers
contained in the box of accessories.
2
1
10. Then refit the bracket cover.

8.6 Fitting the plinth

Alignment height of 820 mm
• If using a 140 to 170 mm plinth, make
a cut out as shown.
170-220 mm
900 mm
30-100 mm
• If using a plinth higher than 100 mm
but less than 140 mm, cut the height
compensation strip supplied with the
appliance to the required depth and fit
it between the plinth and the
ventilation grille, pressing it into
position below this grille.
• If using a 100 mm plinth, fit the
complete height compensation strip.
ENGLISH 17
3
820-870 mm
140-190 mm