Maintenance - Stanley SGC-13000N-T Originalanleitung

Idle Speed
Set throttle control lever to its "low" position
to reduce stress on the engine when compacting
is not being performed. Lowering the engine speed
to idle the engine will help extend the life of the
engine, as well as conserve fuel and reduce the
noise level of the machine.

MAINTENANCE

Maintaining your compactor will insure long
life to the machine and its components.
Preventive Maintenance
1. Turn off engine. Engine must be cool.
2. Keep the engine's throttle lever in its SLOW
position, and remove spark plug wire from spark
plug and secure.
3. Inspect the general condition of the plate
compactor. Check for loose screws, misalignment
or binding of moving parts, cracked or broken
parts, and any other condition that may affect its
safe operation.
4. Remove all debris from the plate compactor with
a soft brush, vacuum, or compressed air. Then
use a premium quality lightweight machine oil to
lubricate all moving parts.
5. Clean the bottom of the compactor base as soon
as it begins to pick up soil being compacted. The
unit can not do a good job if the bottom surface is
not smooth and clean.
6. Replace spark plug wire.
Never use a "pressure washer" to clean
your plate compactor. Water can penetrate
tight areas of the unit and cause damage to
spindles, pulleys, bearings, or the engine. The use
of pressure washers will result in shortened life
and reduce serviceability.
Checking V-Belt(s)
To ensure optimum power transmission from
the engine to the eccentric shaft, the V-belt(s)
must be in good condition and operate under
proper tension.
1. Turn off engine. Engine must be cool.
2. Remove the belt guard to access the V-belt(s).
3. Check the condition of the V-belt(s). If any V-belt
is cracked, frayed, or glazed, it should be replaced
as soon as convenient.
4. Check the V-belt tension by squeezing them in
the center. The normal deflection on each side
should be 9mm (3/8" to 13mm (1/2" with moderate
pressure from your thumb or finger.
On new machines or after installing a new belt,
check belt tension after first 20 hours of operation.
Check and adjust belt every 50 hours thereafter.
Tensioning V-Belt
Proper belt tension is critical to good
performance.
Proper adjustment will assure long belt life.
Too much or too little belt tension will cause
premature belt failure.
Compactor with optional water sprinkler kit
1. If the plate compactor you bought is with
water tank, please pull the water tank up
from the chassis as shown.
13
G
B