Klarstein Food Locker 650 Bedienungsanleitung Seite 36

EN
36
How to use with vacuum bottle stoppers
The unit can vacuum bottle with bottle stoppers. If you cannot finish a bottle of wine
at one time, or you need to preserve a bottle of non-carbonic acid drink, edible oil,
a bottle of juice or any liquid else that is stored in a bottle, you can use the YJS603 to
vacuum the bottle with a bottle stopper.
1. Plug the vacuum bottle stopper to the bottle. Please allow at least 2.5cm distance
between the bottom of the stopper and the surface of the liquid.
2. Connect the hose to the accessory port of the machine and the other end to the port
of the bottle stopper.
3. Press "Accessory" button, the machine starts to vacuum.
Note: Press On/Off button to stop the machine's all working processes.
4. After the vacuum cycle is complete, the machine will stop automatically. Remove the
hose from the stopper.
5. Put the bottle vertically in a plane surface. Make sure the liquid does not touch the
stopper.
6. Simply remove the stopper if you want to open the bottle.
How to Impulse Seal
Sometimes things do not need to vacuum seal, they only need to seal. So Impulse Seal
mode is added in this machine. When enter into the Impulse Seal mode, you don't need
to press any button but only open and close the lid to seal the bag.
1. Press "+"/"-"button to set the seal time;
2. Press Impulse Seal button, the Impulse Seal light is on. The machine enters into
Impulse Seal mode (if the lid is close, LED shows C; if the lid is open, LED blinkingly
shows the seal time);
3. Put the bag mouth across the seal wire and into the chamber. Close and press the
lid, the machine detects that the lid is close then enter into Seal mode. The digits in
LED counts down from preset seal time to 0. The machine will release air and lid,
then beep when the process is finished.
Note: Press On/Off button to stop the machine's all working processes.