Setting The Address With The Switches - Märklin m48 Bedienungsanleitung

Up to 4 users can be digitally controlled independently of
each other with the m84 decoder. To do this the decoder
needs an address. This can be set either with the externally
accessible dip switches or with programming from your
controller. We strongly recommend setting the address with
the dip switches.
ON
1 2 3 4 5 6 7 8 9 10
12

Setting the Address with the Switches

Up to 4 users can be can be connected to the m84 decoder.
The address of the first user is set. The other 3 users
automatically are assigned the corresponding sequential
addresses after this address.
There are 10 individual dip switches. The address is set with
switches 1 to 9 (switch 10 is for selecting the digital protocol
MM / DCC). The number value set with the switches gene-
rates the address for the first user connected to the decoder
The table on page 19 shows the switch settings for addres-
ses 1 – 160.
Note: There must be no current present in the decoder
before changing the dip switch settings. This means that
any external current supply connected to the decoder must
be turned off.
Example:
Switches 3 and 4 are ON, all of the others are off:
4 + 8 = 12 Adding the values of the switches
-> Group Address 12
12 x 4 - 3 = 45 Calculating the individual address
-> Individual addresses 45 – 48
The 4 users connected to the decoder have the individual
addresses 45 to 48.