Mounting Yokes/Crosses Of A Wide Angle Joint - walterscheid SW41 Bedienungsanleitung

YOKES/CROSSES OF A WIDE ANGLE
8.2

Mounting yokes/crosses of a wide angle joint

(1) Double yoke
(2) Grooved yoke with mounted cross (see
Chapter 7.2 for mounting)
(3) Bearing bush
(4) Circular blank
(5) Circlip
1. Insert an appropriate mandrel (1) into
the quick-change system. The diameter
of the mandrel must correspond to the
drill hole diameters of the yokes.
2. Align the position of the mandrel (1)
opposite the bearing bush of the cross.
3. Grease the bearing needles of all
bearing bushes generously.
4. Insert the cross into the yoke.
5. Place the first bearing bush (2) on the
cross journal. Pay attention here that no
bearing needles fall out of the bearing
bush.
DISMANTLING/MOUNTING
JOINT
Always start the mounting of the cross with the inboard yoke
(slip-on yoke or grooved yoke).
Fig. 40
Fig. 41
45