walterscheid SW41 Bedienungsanleitung Seite 88

7 Dismantling/mounting yoke/cross
7.1 Dismantling yoke /cross
1. Pull the drive shaft apart.
2. Remove the safety device of the
defective drive shaft half. Observe the
operating manual of the drive shaft for
this.
3. Lubricate the cross kit.
This minimises the risk of the bearing
→
needles falling out of the bearing
bushes.
4. Insert an appropriate mandrel (1) into
the quick-change system. The diameter
of the mandrel must correspond to the
drill hole diameters of the yokes.
5. Align the position of the mandrel (1)
opposite the bearing bush of the cross.
6. Release the first circlip of the yoke.
6.1 For this, press the bearing bush
against the mandrel for a short
time and operate the foot switch
simultaneously.
The circlip is released.
→
DISMANTLING/MOUNTING
YOKE/CROSS
Observe the operating manual of the drive shaft for the removal
and installation of the safety devices. Download the
corresponding operating manual from our website if necessary.
http://www.gkn-walterscheid.de/downloadcenter/anleitungen/
Fig. 14
Fig. 15
35