Dismantling/Mounting Yoke/Cross - walterscheid SW41 Bedienungsanleitung

6.2 Remove the first circlip.
7. Release and remove the second circlip
on the opposite side. Repeat the action
step 6 for this.
8. Drive both bearing bushes out of the
yoke.
8.1 For this, press one bearing bush
(1) against the mandrel (2) and
operate the foot switch simultane-
ously until you can remove the first
bearing bush (3).
8.1.1 Turn the yoke over if you
cannot remove the first bear-
ing bush from the yoke.
8.1.2 For this, press one bearing
bush (1) against the drift
punch (2) and operate the
foot switch simultaneously
until you can remove the first
bearing bush (3).
DISMANTLING/MOUNTING
YOKE/CROSS
Fig. 16
Fig. 17
Fig. 18
Fig. 19
36