Temperature Calibration - Zodiac AquaLink TRi Montage- Und Gebrauchsanleitung

3.5.7 Name auxiliaries
Menu to give a name to each one of the 3 auxiliaries corresponding to the 3 relays available in AquaLink TRi®.
INSTALL SETTINGS
Color Lights >
Label Aux >
Temp Calibrate >
Assign JVA >
Ext. SWC Power >
 More 
3.5.8 Temperature calibration
This menu is used to adjust the water temperature displayed by the AquaLink TRi®. This makes it possible to
correct an eventual difference between the temperature displayed by the heating system and/or a floating
thermometer.
Water temperature calibration is used to recover a difference of up to +/‐ 4°C. If the difference to recover
is greater, make sure the problem does not come from the temperature sensor you are trying to align
with.
INSTALL SETTINGS
Color Lights >
Label Aux >
Temp Calibrate >
Assign JVA >
Ext. SWC Power >
 More 
3.5.9 Solar priority (if installed)
This menu only appears if a water temperature sensor for solar heating has been installed on terminals 3 and 4
of the green connector on the AquaLink TRi® electronic board (see §2.4.3).
If solar heating priority is activated, the solar heating will be used first over the traditional heating.
INSTALL SETTINGS
Color Lights >
Label Aux >
Temp Calibrate >
Solar Priority >
Assign JVA >
 More 
The use of the "Solar Priority" function implies the mandatory use of a motorised 2 channel valve of the
"JVA" (= Jandy Valve Actuator) type of which availability depends on the country you are in. This
function will not therefore be available in all countries.
3.5.10 Assign JVA
This menu is exclusively for the use of motorised 2 channel "JVA" (= Jandy Valve Actuator, see wiring diagram
§2.3.1) valves. Availability is therefore variable depending on each country.
The use of JVA motorised valves is designed to manage a "Pool + Spa" combination, or when the filtering is
switched to the Spa circuit when the Spa is in use.
AquaLink TRi® can manage 3 "JVA"s:
 a motorised valve for suction = "Intake" on the electronic board and "Input" on the AquaLink TRi® menu.
 a motorised valve for discharge = "Return" on the electronic board and "Output" on the AquaLink TRi® menu.
 a motorised valve for solar heating = "Solar" on the electronic board and "Solar" on the AquaLink TRi® menu.
H0369400.B.EN – 2013/03
LABEL AUX
Aux1 >
Aux2 >
Aux3 >
TEMPERATURE
CALIBRATE
Water : 25°C
SOLAR PRIORITY
. Enable .
 Disable
Label : Aux1
. <Default> .
Aerator
Blower
Backwash
Chlorinator
 More 
17