Zodiac AquaLink TRi Montage- Und Gebrauchsanleitung Seite 39

Variable speed pump adjustment procedure:
SET PUMP TYPE
1‐Speed
2‐Speed
 VSP
VSP Setup >
 Select the variable speed pump model "VS Pump Model"
 "Speed" = selection and memorisation of the different speeds. Six choices are possible:
- Speed 1 assigned to the "Pool Mode"
- Speed 2
- Speed 3 assigned to the pressure cleaner (if present)
- Speed 4
- Speed for heating (if a specific speed is to be assigned when heating is operating)
- Solar speed (if there is solar heating)
 "Assign speed. " = assign a speed to each auxiliary. The speed for the "Pool Mode" is assigned by default to
"None" because it is related to the filtering relay. One of the 3 auxiliaries can be selected for speeds 2, 3, 4 and
heating.
 "Priming" = choice of the speed and duration (from 1 to 5 minutes) of the pump priming mode.
 "Min/Max" = minimum and maximum speeds authorised by the pump. The default "Min/Max" settings are
respectively: 600 rpm and 3450 rpm.
 "Anti‐freeze" = choice of the pump speed when activated in "Anti‐Freeze" mode.
In some cases a specific connection cable will need to be acquired to connect a variable speed pump to the
AquaLink TRi® (not supplied by Zodiac®).
In all cases, please refer to the installation instructions supplied with the variable speed pump for all of
its operating and safety settings.
Zodiac® cannot be held liable for failure to comply with the manufacturer's instructions.
3.5.6 Lighting
Menu to configure certain multicoloured LED lighting. Once the Led lighting has been assigned to one of the 3
auxiliaries, different colours can be managed when turning on the lighting.
INSTALL SETTINGS
Color Lights >
Label Aux >
Temp Calibrate >
Assign JVA >
Ext. SWC Power >
 More 
Only Led lighting compatible with the list displayed on the AquaLink TRi® is concerned by the "Lighting"
menu. All other types of classic incandescent bulb lighting are not concerned (basic electric connection to
one of the 3 relays).
H0369400.B.EN – 2013/03
VSP SETUP
Model >
Speeds >
Assign Speeds >
Prime >
Min/Max >
Freeze >
SELECT LIGHT
Jandy Color
Jandy Led .
Intellibrite
Color Logic
ASSIGN TO AUX
Jandy LED
Aux1 JL.
Aux2
Aux3
EN
16