Heating System - Zodiac AquaLink TRi Montage- Und Gebrauchsanleitung


ACTUAL READING
Current pH : 7,3
Setpoint : 7,2
Current ACL : 3
Setpoint : 4
If the pool is fitted with a Zodiac® TRi® salt water chlorinator connected to the AquaLink TRi®, specific menu lines
for the chlorinator will appear in the "Programming" menu :
  Boost = shock‐chlorination activation for a total of 24 hours.
  Low = limitation to 10% chlorine production if the cover is shut and/or wintering is active.
button when the line is highlighted to activate or deactivate the mode.
Press the
  Chlorine Prod. =  TRi® chlorine production setting.
The TRi® chlorine production setting is only displayed if it is a stand alone TRi® or a pH TRi (the TRi PRO has
its own chlorine production regulation).
  pH/ACL reading =  displays the current values and the set points for pH and ACL.
The "pH/ACL Reading" menu line only appears if the TRi® chlorinator is operating and if it is fitted with a
Tri pH or TRi PRO module. Only pH information will be displayed for a TRi® with the TRi pH module.
3.4.2 Heating system
You can activate or deactivate the heating function by managing 2 different set points. These set points are called
"Temp.1" and "Temp.2".
Zodiac
14 : 26
Pool Mode Off
Temp1 Off
Temp2 Off
Aux1 Off
Aux2 Off
 More 
Heating can only start if at least one of the 2 set points is activated and the water temperature is below the active
set point. Note: approximately 1 minute will pass before the "Temp.1" or "Temp.2" set point switches from
"Auto" to "On".
 The display will alternate between "26°" and "Auto" if the pool water temperature is greater than or
equal to the set point.
 The display will alternate between "26°" and "On" if the water temperature is below the set point AND
"Pool Mode" is "On".
 If both set points are active at the same time, the highest set point temperature will have priority.
 If there is a need to immediately cut filtering, press the
equipment connected to the AquaLink TRi® will be shut down, even if a timer is running.
Zodiac
14 : 26
Pool Mode Off
Temp1 26°
Temp2 Off
Aux1 Off
Aux2 Off
 More 
 If you stop the "Pool Mode", the filtering will observe a 5 minute delay for the cooling of the heating
H0369400.B.EN – 2013/03
POOL HEAT
Enabled
Set To : 26°C
POOl HEAT
Enabled
Set To : 28°C
Zodiac
14 : 26
Pool Mode Off
Temp1 26°
Temp2 Off
Aux1 Off
Aux2 Off
 More 
button for 3 seconds. All the pool
Zodiac
14 : 26
Pool Mode Off
Temp1 26°
Temp2 28°
Aux1 Off
Aux2 Off
 More 
EN
12