Self-Clean Function; Ironinig Tips - Fakir THERA Bedienungsanleitung

Self-clean function

We should clean the unit regularly according to hardness of water and using frequency.
1. Fill water into the water tank and set the temperature selector to Max position
2. Connect into power supply and indicator light will be illuminated, make sure Steam
button is in the Dry position, then place iron as fig.4
WARNING!
Never pour white vinegar or other liquid cleaners
for eliminating calcium into water tank!
3. Once the light is off, hold the iron over the sink and turn steam button to SELF
CLEAN position (Fig.3) with a little force. Steam and boiling water will come out of
the soleplate while impurities and flakes will be flushed out.
4. Release the button as soon as water in the water tank has been used up.

Ironinig Tips

1- Always check first whether a label with ironing instructions is attached to the article.
Follow these ironing instructions in any case.
2- The iron heats up quicker than cooling it down, therefore, you should start ironing the
articles requiring the lowest temperature such as those made of synthetic fibre.
3- If the fabric consists of various kinds of fibres, you must always select the lowest
ironing temperature to iron the composition of those fibres.
4- Silk and other fabrics that are likely to become shiny should be ironed on the inner
side. To prevent staining do not spray water straight on silk or other delicate fabrics.
5- Velvet and other textures that rapidly become shiny should be ironed in one direction
with light pressure applied. Always keep the iron moving at any moment.
6- Pure woollen fabrics (100% wool) may be ironed with the iron set a steam position.
Preferably set steam button to the maximum position and use a dry p cloth as a mat.
NOTE!
When ironing woolen fabrics, shining of the fabric
may occur. So it is suggested that you should turn
the article inside out and iron the reverse side.
THERA
17
GB