3 Commissioning
Safety information
Before commissioning, it is essential that you read the general information
at the beginning of this manual.
Contents of pack
1 Telephone base
1 Telephone connection cable
1 Operating Manual
Connecting the telephone receiver
After unpacking your telephone, you must first connect the telephone recei-
ver to the base unit. First take the one end of the spiral cable and plug it
into the socket at the bottom of the receiver. Plug the other end of the spiral
cable into the socket on the left side of the phone.
Connecting the telephone
Connect the telephone cable supplied to the telephone socket and the tele-
phone jack on the rear side of the telephone.
The telephone works using the tone dialling system.
1 Telephone receiver
1 Spiral cable
Commissioning
GB
19