Optional Accessories; After Use - Makita DLS714 Betriebsanleitung

Bevel angle
0° bevel angle
Fig.57: 1. Lever 2. Arm holder 3. 0° degree bevel
button
1. Push the carriage toward the guide fence and
tighten two clamp screws to secure the carriage.
2. Lower the handle fully and lock it in the lowered
position by pushing in the stopper pin.
3. Loosen the lever at the rear of the tool.
4.
on the right side of the arm two or three revolutions
counterclockwise to tilt the blade to the right.
5.
carefully until the side of the blade makes a perpendic-
ular angle with the top surface of the turn base. Use the
triangular rule, try-square, etc. as a guide. Then tighten
the lever securely.
Fig.58: 1. Triangular rule 2. Saw blade 3. Top sur-
face of turn table
6. Make sure that the pointer on the arm indicates 0°
on the bevel scale. If it does not indicate 0°, loosen the
so that it indicates 0°.
Fig.59: 1. Bevel scale 2. Pointer 3. Screw
45° bevel angle
Fig.60: 1.
1. Loosen the lever and tilt the blade to the left fully.
2. Make sure that the pointer on the arm indicates
45° on the bevel scale. If the pointer does not indicate
on the right side of the arm until the pointer indicates
45°.

After use

After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding por-
tions with machine oil to prevent rust.
When storing the tool, pull the carriage toward you fully
so that the slide pole is thoroughly inserted into the turn
base.
To maintain product SAFETY and RELIABILITY,
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
4. Arm 5. Release
23 ENGLISH
OPTIONAL
ACCESSORIES
WARNING:
These Makita accessories or
attachments are recommended for use with your
any other accessories or attachments may result in
WARNING:
Only use the Makita accessory
or attachment for its stated purpose. Misuse of
an accessory or attachment may result in serious
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Carbide-tipped saw blades
• Vise assembly (Horizontal vise)
• Vertical vise
• Holder assembly
• Holder rod assembly
• Set plate
• Dust bag
• Triangular rule
• Hex wrench
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
The use of