Power Down - SPL Performer m1000 Kurzanleitung

Performer m1000 – Quickstart
Power up
10
Turn down the volume of the connected preamplifier.
Switch on mains switch on the rear of the Performer m1000 (On = I).
11
Power LED lights up.
Standby
The Standby function requires an AMP CTL connection to an SPL device
12
supporting AMP CTL output(s) or a 12V trigger controller.
In standby the Power LED is dimly lit.

Power down

13
Turn down the volume of the connected preamplifier.
Switch off mains switch on the back of the Performer m1000 (Off = O).
14
Power LED no longer lights up.
Gain trim
You can trim the amplification gain with the trim switch on the rear of the unit to
15
adjust speaker playback levels in multi-speaker setups.
4
PROTECT PWR TEMP
VOLTAiR
Performer
m1000
120V DC Audio Rail
11 12 14
Performer m1000 – Quickstart
EN
DE
Mono Power Amplifier
Power LED
5