Operating The Brakes - Vermeiren Forest Narrow Gebrauchsanweisung

2.13 Operating the brakes

Let go of the joystick to stop the electric wheelchair.
2.13.1 Parking the electric wheelchair
Once your electric wheelchair has been turned off, no command can be sent to the driving
system. Always park your electric wheelchair on sites that are easy accessible and on
horizontal surfaces that the four wheels are touching the ground.
2.13.2 Operator controls
* DX2 controller or Shark controller
The instructions for use from the operator controls you can find in the seperate user manals
of the operator controls that is included with your wheelchair.
Changing the software is only allowed by Vermeiren. For changes in the software
contact Vermeiren.
2.13.3 Adjusting operator control
L L L L
CAUTION:
Risk of pinching - Do not put your fingers between the operator
control and the other parts when positioning the operator control.
The operator controls horizontal position can be changed:
1. Loosen screw just under the armpad a little bit.
2. Move the operator control to the desired position or remove the operator control.
3. Retighten screw
If you pull screw to the side, the operator control can be turned to the side.
NOTE: Depending on the features of your wheelchair, screw
beneath the guide tube ➁ .
1
2
properly.
Page 17
Forest, Forest Narrow
2012-12
could also be located