Thermal Fuse; Anti-Tipping (B78); Installation And Adjustment; Tools - Vermeiren Forest Narrow Gebrauchsanweisung

2.23 Thermal fuse

1
To be able to use the electric wheelchair again, remove the overload and wait till the motor
has cooled down. Then gently press the thermal safety mechanism back in. Your wheelchair
is now ready for use again.

2.24 Anti-tipping (B78)

L L L L
CAUTION:
Risk of injury - Check that the anti-tipping is working before driving
with the electric wheelchair.
3

Installation and adjustment

The instructions in this chapter are for the specialist dealer only.
The Forest has been designed as a rear wheel drive electric wheelchair.
L L L L
WARNING:
Risk of unsafe settings - Use only the settings described in this
manual.
L L L L
WARNING:
Risk of tipping over - Variation allowed adjustments can still change
the stability of your wheelchair (tilt back or sideways).
3.1

Tools

The Vermeiren Forest shall need following tools:
•
Wrench set n° 10 to n° 24
•
Allen keyset n° 3 to n° 4
•
Screwdriver Phillips head
3.2

Manner of delivery

The electric wheelchair shall be delivered with:
•
Framework with armrests, operator control, rear and front wheels, seat and backrest
(optional: electrically adjustable seat/back unit, lift system)
•
1 pair of footrests (standard: B06; removable, can be turned outwards)
•
2 x drive batteries, 2 x drive motors
•
Impulse S charger (8A) + manual of Impulse S charger
•
Electronics
•
Tools
•
Operator control + manual operator control
•
Accessories
•
Back strap
To protect the motor against overload, on the right side of
the seat frame there is a thermal safety mechanism
will automatically cut off the motor to prevent overheating
and thus rapid wear and tear or breakdowns. This can occur
if you go up or down slopes that exceed the maximum
gradient indicated. Nominal loads exceeding the maximum
could also trigger the safety mechanism.
For your safety your electric wheelchair is equipped with an anti-
tipping that works with a suspension system, and when crossing
small obstacles (no higher than 70 mm) tips back a little, yet
overtipping is prevented by a stopping mechanism. Do not remove
the anti-tipping device as your wheelchair will no longer be secured
against accidentally tipping over.
Page 26
Forest, Forest Narrow
2012-12
that