Appliance Description - STIEBEL ELTRON SHZ 30 LCD Bedienung Und Installation

OPERATION

Appliance description

3. Appliance description
The appliance electrically heats domestic hot water with the con-
nected heating output or with rapid heating. The electronic control
unit makes energy saving adjustments easier. Subject to the power
supply and your usage pattern, the water is heated up automati-
cally to the set temperature. The standard display tells you about
the available mixed water volume, the heat-up status and ECO
mode. In addition, any faults and scale build-up on the flanged
immersion heater are shown.
The internal steel cylinder is coated with special directly applied
enamel and is equipped with an impressed current anode. When
the power supply is on, the anode actively protects the internal
cylinder from corrosion.
The appliance is protected from frost in all operating modes when
the power supply is present. The appliance starts and stops at the
right times when the water has been sufficiently heated. The water
supply lines and the safety assembly are not protected against
frost by the appliance.
Menu key
Rapid heating key
www.stiebel-eltron.com
e l c t r o n i c
Standard display with available mixed water volume
You can use the appliance in single circuit, dual circuit or manual
rapid heat-up operation.
Single circuit operation
In this operating mode, the appliance heats up the water automati-
cally with the connected heating output at any set temperature
setting.
Dual circuit operation
During off-peak tariff periods (power supply utilities' enable
times), the appliance automatically heats up the water content
with the connected heating output at any set temperature setting.
You can also start rapid heating.
Manual rapid heat-up operation
The appliance heats the water if the rapid heating key has been
pressed. Once the selected temperature has been reached, the
appliance switches off and does not restart.
c o m f o r t
Setting the set temperature:
Plus key
Minus key
SHZ LCD | 29