General Information; Relevant Documents; Units Of Measurement; Appliance Description - STIEBEL ELTRON ZWVK 1 Installation

INSTALLATION

General information

1. General information
These instructions are intended for qualified contractors.
Note
Read these instructions carefully before using the ap-
pliance and retain them for future reference.
Pass on these instructions to a new user if required.
1.1

Relevant documents

Operating and installation instructions of the relevant
storage heater
Note
Please see storage heater operating and installation
instructions for information on "Customer service and
guarantee" and "Environment and recycling".

1.2 Units of measurement

Note
All measurements are given in mm unless otherwise
stated.

2. Appliance description

1
1 Floorstanding installation
2 Installation with Vario brackets
The Vario mounting bracket allows the storage heater to be
positioned with a ground clearance of 100 mm.
As long as the storage heater can be mounted on a wall with
sufficient load bearing capacity, the bracket only needs to be
secured to the underside of the storage heater feet.
If no suitable wall is available for installation, the bracket must
be secured to the floor and to the feet of the storage heater.
4 |
240413-43578-9657_ZWVK_1_ZWVK_2_de_en_fr_nl_cs_sk_pl_hu.indb 4 240413-43578-9657_ZWVK_1_ZWVK_2_de_en_fr_nl_cs_sk_pl_hu.indb 4
2
3. Installation
4
1 Fixing screws
2 Top section
3 Adjusting screw
4 Bottom section
3.1 Installation when securing to a wall
f Unscrew both securing screws from the Vario bracket.
f Position the Vario brackets against the installation wall,
the same distance apart as the storage heater feet (see
operating and installation instructions, chapter "Specifica-
tion / Dimensions and connections").
f Place the storage heater, without its air discharge grille,
front panel and right side panel, with its feet on the Vario
brackets.
f Remove the air routing assembly from the storage heater
as described in the operating and installation instructions
for the heater.
f Secure the storage heater to the Vario brackets with
screws.
f Check the alignment of the storage heater using a spirit
level. If necessary, correct the level of the storage heater
using the adjusting screw on the Vario bracket.
f Continue with the installation of the storage heater as
described in the operating and installation instructions for
the storage heater.
1
2
3
ZWVK
13.08.2021 10:41:50 13.08.2021 10:41:50