Special Information; General Information; Safety Instructions; Structure Of Safety Instructions - STIEBEL ELTRON SHZ 30 LCD Bedienung Und Installation

SPECIAL INFORMATION | OPERATION

SPECIAL INFORMATION

- The appliance may be used by children aged 8
and older and persons with reduced physical,
sensory or mental capabilities or a lack of ex-
perience and know-how, provided that they are
supervised or they have been instructed on how
to use the appliance safely and have understood
the resulting risks. Children must never play with
the appliance. Children must never clean the ap-
pliance or perform user maintenance unless they
are supervised.
- The connection to the power supply is only per-
missible as a permanent connection in conjunc-
tion with the removable cable grommet. Ensure
the appliance can be separated from the power
supply by an isolator that disconnects all poles
with at least 3 mm contact separation.
- Fix the appliance in position as described in
chapter "Installation / Preparations".
- Observe the maximum permissible pressure (see
chapter Installation / Specification / Data table).
Sealed unvented operating mode:
- The appliance is pressurised. During the heat-up
process, expansion water will drip from the safety
valve.
- Regularly activate the safety valve to prevent
it from becoming blocked, e.g. by limescale
deposits.
- Drain the appliance as described in chap-
ter "Installation / Maintenance / Draining the
appliance".
- Install a type-tested safety valve in the cold water
supply line. Please note that, depending on the
static pressure, you may also need a pressure re-
ducing valve.
- Size the drain so that water can drain off unim-
peded when the safety valve is fully opened.
- Fit the discharge pipe of the safety valve with
a constant downward slope and in a room free
from the risk of frost.
- The safety valve discharge aperture must remain
open to atmosphere.
www.stiebel-eltron.com
OPERATION
1.

General information

The chapters "Special Information" and "Operation" are intended
for both the user and qualified contractors.
The chapter "Installation" is intended for heating contractors.
Note
Read these instructions carefully before using the appli-
ance and retain them for future reference.
Pass on the instructions to a new user if required.
1.1

Safety instructions

1.1.1 Structure of safety instructions

KEYWORD Type of risk
!
Here, possible consequences are listed that may result
from failure to observe the safety instructions.
f Steps to prevent the risk are listed. f
1.1.2 Symbols, type of risk
Symbol Type of risk
Injury
!
Electrocution
Burns
(burns, scalding)
1.1.3 Keywords
KEYWORD Meaning
DANGER Failure to observe this information will result in serious
injury or death.
WARNING Failure to observe this information may result in serious
injury or death.
CAUTION Failure to observe this information may result in non-
serious or minor injury.
SHZ LCD | 27